Printable View
Hi all, does anyone know of any decent Spectrum analyzer plug ins which I can run as a VST off my main output from Cubase so I can see the frequency range in real time, or is that not how it should work? At the moment I'm bouncing my mix down to audio and using the standard SX spectrum analyzer on the resulting file, just wondered if there was another way.
yeah!!!
would be nice to see 1 of these. i have been looking for 1 also.
:clap: thanks for reminding me
There's the Voxengo SPAN one ,which I use. :D
http://www.kvr-vst.com/get/1023.html
Also the Elemental Audio System's Inspector But i found that Pretty cack. :?
I use EAS Inspector. It has loads of features, and it tells you how much headroom you have.
Technical
Spectrum analyzer
Customizable alarms for:
- Headroom
- Channel balance
- Number of times audio waveform is clipped
- Number of consecutive samples clipped
- Total number of clipped samples
Peak meters
RMS meters
Channel balance meter
Customizable meter caution and warning zones
Headroom displays/readouts
Clip counters/readouts
Supports sampling rates up to 192 kHz
Altivec/Velocity engine optimizations
Multi-processor/Advanced multi-processor (AMP) capable
Interface
Enable/disable spectrum analyzer
Enable/disable individual alarms
Set individual alarm levels using arrow controls
General
Integrated SAVE and LOAD
and it`s a FREE!!!! Vst plugin
http://www.elementalaudio.com/produc...oad/index.html
Will give both of those a try, cheers geezers.
EAS Inspector looks great!! Thx for the tip. :!:
cheers mate :clap: :clap: will check
cheers,
I was going 2 sugest the waves 1... I know I've seen an analiser pluggo somewhere ;)
Z