Sketch out a table along these lines...

Code:
+-----------------------+
|     |     |     |     |
|     |     |     |     |
|-----|-----|-----|-----|
|     |     |     |     |
|     |     |     |     |
+-----------------------+
That's two long horizontal bits (top and bottom), 5 medium vertical bits (sides and shelf dividers), and then 4 small horizontal bits (shelves themselves).

Put in some rough measurements - e.g. make the whole thing long enough for all your equipment (and then some), try and make each of the boxes that make up the frame at least 12" X 12".

Take the measurements down to B&Q and get them to cut out the pieces in MDF for you.

Buy some nails, and some little plastic brackets.

Put the whole lot together and voila....

Your own custom made deck stand, with space for all your equipment on top, and storage for shitloads of vinyl underneath. Your parents will be impressed.

Will take a photo of ours at some point if people are interested.

(Though ours was slightly different in the end).