Zigo's PC Problems

[zigojacko]

Went to boot up myself one morning and received after BIOS check ---->

Primary Master Hard Disk Failure
Primary Slave Hard Disk Failure
Floppy Disk Failure

How gutted am I??? :cry: :cry: :cry: :cry: :cry:

This basically means going by the error messages that both my hard drives have failed (one being only 6 months old - 60 Gig beauty!!!) and floppy disk drive have failed all over one night. It's not possible surely???

So stripped my p.c down and started playing about with it to see if my process of elimination i could see what the actual problem was if it wasn't hard drive failures. I was unable to access the hard drives but could be a fault with the IDE controllers on the motherboard or the actual floppy link cable inside the system unit...


I so hope my hard drives aint knackered coz i have about 40 Gig of work and muzic (mp3's, samples and everything) all my own produced from software e.t.c... and all my internet related programs, i am also a website builder/developer and am running websites from my p.c too and all the files for them are stored on my hard drives too...

absolutely devasted :cry:


anyone else experienced any problems like this before... any advise anyone? i just dont fancy the liklihood of spending a couple of hundred quid sorting this problem out now - lol

thanx :)

[EmotionComplex]

Id remove the slave and make sure the jumpers on the master are set for a single master use (some bios's wont accept its there otherwise)

and see if itll boot up from the single harddrive, try swapping the master with the slave and botting the previous slave drive as the master, if the primarys gone bust the slave wont do anything either so you might be able to salvage that as your main drive until its sorted. if that doesnt work and you have any spare ide cables swap them round incase thats it

[zigojacko]

cheers for that m8 :lol:

ive actually tried all of that and it didnt solve the problem... quite strange really because adjusting the jumpers didnt seem to actually do a lot... and configured the BIOS for the slave and master and just couldnt resove it...

of the whole I.T scene, the internal components of the system unit is probably my weakest point so maybe I need to get someone that knows a bit more than me about it to have a look... I may be not doing something correctly perhaps, lol...

[zigojacko]

apparently I can retrieve my data from my old hdd :) i really hope so coz i have gigs of muzic work and web building work on there...

[dan the acid man]

there is software out there that enables you to retrieve data, but most that i have used are'nt that good, if you take it to a specialist data recovery company, they will probably do a better job, but it's expensive.
Have you tried the hd since, if its a problem mechanically, sometimes they will work again for a short time before they get too warm again, then leave it for a week or so, and try it again.
This is how i got most of my data back from a hd that went down

[zigojacko]

yeh, don't fancy forking out shed loads for a professional to retrieve it... my mate says he can do it which is kewl :)

yeh, have tried it recently and no joy... bewildered as to what it could be

[dan the acid man]

hd's are like that, they are very mechanical, so they can just give up with no warning

[Barely Human]

Sounds like your motherboard is toasted to me mate. If it was just one hardrive gone, then it could be 3 things - The hardrive, the cable, the motherboard. But i really cant see 3 drives, or 3 cables going in one night, so its probably the motherboard...

[dan the acid man]

it's an old post iq, if it was his MB he would have realised by now i reckon :lol:

[dan the acid man]

unless of course its an old spare pc with the same motherboard etc

worth trying the hd in another board if it is

[Barely Human]

it's an old post iq, if it was his MB he would have realised by now i reckon :lol:

Ah right :lol: Send a slap my way and wake me up :lol:

[dan the acid man]

*thwack!!!!!!!!!* :lol: